Contemporary Solo Newel Post Caps
Solo Newel Post Caps will fit onto any 90mm x 90mm Newel with a flat top allowing you to refurbish your existing newels and change just the spindles and rails to the Solo range, saving you time and money
Contemporary Spindles are designed to be used with any handrail with a 41mm groove allowing you the freedom to create your own contemporary stair balustrade.
The Contemporary Solo system can fit onto any newel post with a flat face, so you can leave your newels in place and just replace the spindles and rails refurbishing your staircase in a matter of hours.
Contemporary Solo Stair Balustrade is a stunning solution for those who like to use traditional stair parts, but want a more modern look and feel.
Contemporary Solo Cap Range
Select from the following timber and metal combinations
- Contemporary Solo Pine and Chrome Full Cap (110mm x 110mm x 38mm)
- Contemporary Solo Pine and Chrome Half Cap (110mm x 50mm x 38mm)
- Contemporary Solo Oak and Chrome Full Cap (110mm x 110mm x 38mm)
- Contemporary Solo Oak and Chrome Half Cap (110mm x 50mm x 38mm)
- Contemporary Solo Oak and Brushed Nickel Full Cap (110mm x 110mm x 38mm)
- Contemporary Solo Oak and Brushed Nickel Half Cap (110mm x 50mm x 38mm)
Fitting Contemporary Solo Guide
Download the full fitting instructions from within the Specification TAB above or by Clicking BALUSTRADE FITTING INSTRUCTIONS
Newel Posts are fitted first followed by base rails and handrails.
Newel Post Caps are fitted with a suitable hard setting adhesive such as Gripfill
When fitting spindles to your stair case you must first find the angle of the stairs, this can be achieved using a sliding bevel or angle finder.
Cut your spindles top and bottom to the right angle and length. Try each spindle between the hand and base rail sliding it from the bottom of the staircase to the top. This will ensure any rail run-out will be allowed for.
Once all of your spindles are cut you will need to cut your spindle spacers from the fillet strip provided in our rails. This is cut at the same angle as the stairs making sure that the spindles are spaced no more 99mm apart.
Start at the bottom of the staircase and insert the first spacer followed by a spindle. We suggest dry fitting all of your spindles and spacers before fixing into place then bed all spindles and spindle spacers on PVA wood adhesive. We recommend pinning the spindles in place, panel pins should be inserted below the level of the spindle spacer so the spacer will hide the head of the panel pin.
Counter sink any panel pin heads showing on the spindle spacer into the timber and fill with a matching wood filler
Follow the same procedure for the landing spindles
Staircase Building Regulations
Handrail heights on the staircase are measured from the front bullnose of a step to the top of the handrail.
Spindles must not allow a sphere 100mm in diameter to pass between two spindles
If you are unsure, please contact us or your building inspector for new builds
Free Staircase Planning Service
If you need help understanding what components you need for your staircase then contact us on 01691 691020 or email us a rough plan of your stairs including any photographs and handrail lengths to firstname.lastname@example.org and we will get a quote together for you
You can download the Cheshire Mouldings Benchmark Fitting Instructions manual from here